Visual Reference Guide
To confirm your bumper is indeed fitted with the Appearance Package rear skirt, check for the following.
1 The Appearance Package skirt has pronounced enclosures with sharp edges surrounding each muffler tip. The Stock Bumper has small, rounded enclosures surrounding each tip.
2. The Appearance Package skirt has vertical ribs which provide a "ground effects" appearance as found on racing vehicles. The Stock Bumper has a rounded lower edge and not not include these styling cues.
If you still have concerns regarding the configuration of your vehicle, give us a call, send us a photo, send an email with your VIN, etc...and we'll be glad to assist you.
MX-5 Exhaust Systems
If you're like most Miata MX-5 enthusiasts, one of the first upgrades that you're likely to consider for your car is an upgraded exhaust system. For the earlier 1990-2005  MX5's we found that many of the available exhaust systems on the market produced a modest upgrade in exhaust tone and quality as compared with the stock system. If you simply replaced the exhaust system with a typical bolt-on muffler and connecting-pipe section, depending on the internal design configurations, these systems might produce a near stock like exhaust tone, or a rather noisy, brash, in-your-face exhaust note.

Appearance Package Rear Bumper Skirt

With the introduction of the MX-5 in 2006, many aftermarket exhaust manufacturers quickly set-out to produce an exhaust system. What everyone quickly discovered was that the 2.0-liter engine in the MX-5 produced an exhaust level that was much different than the tone on the earlier engines! Early attempts at using components that were originally designed for these earlier engines were simply not up to the task of taming the rather unruly and loud tone of the exhaust of this engine.

The MX-5 exhaust tone displayed characteristics very much unlike what we had observed on earlier applications. Our findings during early prototype testing revealed the following:

1. Upon lifting the throttle after hard acceleration, the engine produced a significant amount of exhaust noise during deceleration.
2. Low speed, low-to-medium RPM driving in 1st or 2nd gear through a parking lot produced a very pronounced "off throttle" exhaust note.

After extensive experimentation with several different muffler prototype configurations we reached the following conclusion - Mazda's engineering team went to great lengths to silence the exhaust tone that this engine produced! Change any of the exhaust components to less restrictive, more free-flowing aftermarket components and you risk unleashing an obnoxiously loud, raspy, ear-splitting exhaust tone.

So, the challenge was to design a series of exhaust components for the MX-5 that improved exhaust gas flow, provided a comfortable and reasonable exhaust tone, improved performance, and looked great.

Racing Beat's MX-5 Exhaust

A simple and reasonable upgrade to the MX-5 exhaust system is the replacement of the muffler section with an aftermarket unit. Our testing has shown that Mazda's engineers did a very good job with the performance tuning of their muffler unit and squeezing any significant power gains through the use of an aftermarket exhaust is difficult. The Racing Beat team developed several different straight-through mufflers, chambered mufflers, and baffled mufflers in an attempt to optimize power gains, while moderating the "boomy" tones that prevailed under deceleration. We are confident the final system that we now offer has met these objectives and delivers an outstanding combination of quality sound, appearance, and performance. We designed our muffler to appeal to MX-5 owners that drive their cars on a daily-basis and prefer a more mature, modest exhaust tone, yet will provide an aggressive "attitude" when you jump on the throttle!

Easy-to-install, this 304-stainless steel system features dual 3.5" OD tips and can be bolted to the car in minutes using the supplied hardware. The muffler is "cat-back" emissions legal and meets all California sound level requirements. Manufactured at our facility in Anaheim, CA, this Racing Beat component is backed by our 1-Year Limited Warranty.