Mazda Rotary Engine Tools
View
£72.00 inc. VAT £60.00
The Automatic Transmission Counter Balance Weight Puller Tool will remove any automatic transmission balance weight from its taper press fit on the eccentric shaft once the flywheel nut is loosened. This is the same balance weight used with all our lightweight flywheels. (Photo is shown with a Mazda counterweight, which is not included with this tool.)
Item in Stock
Mazda Parts. As an Official Mazda Parts Distributor, we can supply any Mazda Part available.
0 review(s)
Mazda Parts. As an Official Mazda Parts Distributor, we can supply any Mazda Part available.
0 review(s)
£0.00 inc. VAT £0.00
As a registered Mazda Parts dealer distributor, for any part you may need for your Mazda model, kindly send an e-mail to sales@racingbeateurope.com along with your vehicle model and chassis number so we can assist you.
£81.60 inc. VAT £68.00
The Stock Flywheel Puller Tool will remove any stock Mazda flywheel from its taper press fit on the eccentric shaft once the flywheel nut is loosened. This easy-to-use tool is a "must have" for any serious rotary mechanic!
Rotary Flywheel Nut Removal Tool All Rotary's
0 review(s)
£81.60 inc. VAT £68.00
Having the correct tool always makes the job seem easy, right? Although you probably won't be using this tool much, it will certainly pay for itself even if you only use it once! The Flywheel Nut Wrench tool is used to remove or install the 54mm (2.125") flywheel retaining nut. During re-assembly, this tool will allow you to accurately re-torque the nut to the required 350 foot-pounds This tool can be used with the engine in or out of the chassis.
Made in the USA by Racing Beat, Inc.
£54.00 inc. VAT £45.00
The Flywheel Stopper Bar Tool is normally required whenever the rotary engine flywheel retaining nut is being removed or installed. The Racing Beat Stopper Bar bolts to either the stock flywheel, the Racing Beat Flywheel, or equivalent (except Tilton) and prevents the flywheel from rotating during the removal process. This is a GREAT time saving tool, and can be used either in with the engine in the chassis, or while on an engine stand.
Made in the USA by Racing Beat, Inc.