Mazda RX7 FC INDUCTION

The Racing Beat-designed and manufactured cast-aluminium intake manifold is intended for use on a 1987-91 13B TURBO II engine with a Weber 48 IDA or the Racing Beat-modified 51 IDA carburettor (additional porting required for the 51 IDA ).

To fit all RX-7 T11 Turbo Models 1987-1991

As a registered Mazda Parts dealer distributor, for any part you may need for your Mazda model, kindly send an e-mail to sales@racingbeateurope.com along with your vehicle model and chassis number so we can assist you.

The Racing Beat-designed and manufactured cast-aluminum intake manifold is intended for use on a 1984-85 13B 6-Port engine with a Weber 48 IDA or the Racing Beat-modified 51 IDA carburetor (additional porting required).

We offer a Racing Beat-engineered and modified Holley Carburettor Intake Kit for all 1984-92 12A,13B and EGI Stock Port (non-ported) engines.

Racing Beat-Modified High Performance Holley Intake Systems, manufactured for more than 30 years, have established themselves as an ideal way to increase the horsepower output of the rotary engine.

Now available for your Road or Race Car FD3S or T11, this is a specially developed Borg Warner Turbo S364SX-E on a T4 flange that has a special Custom rear wheel fitted to give fast spool and has a 3" VBand attachment for the down pipe.

With this Turbo fitted to our REW RX-8 Circuit Race Car , we have now won many races and Three Championships with over 500 BHP on just a Large Street Port at just 1 bar of boost .

>B>The ideal item to finish the installation of your manual-choke equipped carburetor

As above

As above

As above

As above

As above

As above

As above

These spun-aluminum air horns are intended for use on a Racing Beat-modified Weber 51 IDA carburetor

To fit any 13B with Peripheral Port  (PP) Rotor Housings.

The Racing Beat-designed and manufactured Peripheral Port Intake Manifold mates a Weber 48 IDA or 51 IDA downdraft carburettor, or equivalent throttle body, to the Racing Beat-manufactured 13B peripheral port housings.  Intake Manifold Length is 140mm 

This manifold cannot be used on the Mazda Factory Race MFR housings.