RacingBrake Calliper Brake Kit Installation

RacingBrake Calliper Brake Kit Installation

Tools Needed:

  - 10mm Hex head wrench (required to install calliper to adapter)
  - Assorted wrenches as needed
 

• Jack up the car and place it on safety stands.
• Remove the wheel.
• Disconnect the brake line.
• Detach the existing calliper & bracket from the spindle.
• Remove the rotor from the hub.
• Clean up all mating (bearing hub) surfaces.
• Attach the calliper adapter to the spindle (P/N ADXXX facing you), use the OE calliper bracket bolts (do not tighten yet).
• Install the rotor.
• Place calliper over rotor & attach calliper to the adapter with the 2 ea of M12/M14 calliper bolts supplied.
• Torque the calliper adapter to the spindle per vehicle manufacturer specification (45-50 Ft-Lbs.).
• Position the calliper so that the bleeder screw is pointing up.
• Torque calliper bolts to 55-65 Ft-Lbs.
• Check rotor & calliper alignment.
• Spin the rotor & make sure it rotates freely without any interference.
   
• If you are not replacing brake lines, skip to step 17.
• To install stainless steel brake lines, break the fittings and detach retaining clips, if any.
• Replace the old lines with the new ones using new hardware supplied.
• Bleed the system by following proper bleeding procedures, from the furthermost to the master cylinder first.

https://www.youtube.com/watch?v=fphcB-wB4-Q